DDS數位任意波信號產生器
SPECIFICATIONS |
||||
型號 |
TFG-3605E |
TFG-3610E |
TFG-3615E |
TFG-3620E |
40mHz~5MHz |
40mHz~10MHz |
40mHz~15MHz |
40mHz~20MHz |
|
Waveform (Output A) |
||||
Waveform types |
40 types waveforms, including Sine, Square, Pulse, and 8 sets of arbitrary waveforms |
|||
Waveform length |
1024 points |
|||
Vertical resolution |
8 bits |
|||
Sampling rate |
100MSa/s |
|||
Sine harmonic distortion |
≥40dBc (≥35dBc (1MHz~20MHz) |
|||
Sine total distortion |
≤1% (20Hz~200kHz) |
|||
Square: Rise/fall edge time |
≤35ns, Overshoot: ≤10% |
|||
Square wave duty cycle |
1%~99% |
|||
Frequency (Output A) |
||||
Frequency range: Sine wave |
40mHz~Max.frequency |
|||
Other waveforms |
40mHz~1MHz |
|||
Resolution |
40mHz |
|||
Accuracy |
± (50ppm + 40mHz) |
|||
Amplitude (Output A) |
||||
Amplitude range |
2mVpp~20Vpp, 40mHz~10MHz (high impedance) |
|||
2mVpp~15Vpp, 10MHz~15MHz (high impedance) |
||||
2mVpp~8Vpp, 15MHz~20MHz (high impedance) |
||||
Resolution |
20mVpp (amplitude>2Vpp), 2mVpp (amplitude<2Vpp) |
|||
Accuracy |
± (1% +2 mVrms) (high impedance, RMS, frequency 1kHz) |
|||
Stability |
±0.5% / 3 hours |
|||
Flatness |
±5% (frequency of 10MHz or below ), ±10% (frequency above 10MHz) |
|||
Output impedance |
50Ω |
|||
Offset (Output A) |
||||
Offset range |
±10V (high impedance, attenuation 0 dB) |
|||
Resolution |
20mVdc |
|||
Accuracy |
±(1% + 20mVdc) |
|||
Sweep (Output A) |
||||
Linear sweep or frequency sweep |
||||
Sweep range |
Free to set starting point and end point |
|||
Sweep step |
Higher than any figure of the resolution |
|||
Sweep rate |
10ms~60ms/step |
|||
Sweep mode |
Linear, Log Up or Log Down, Single |
|||
Frequency Modulation (FM) (Output A) |
||||
Carrier signal |
Output A waveforms |
|||
Modulating signal |
Output B signal or External signal |
|||
Modulating deviation |
0%~20% |
|||
Burst |
||||
Burst counts |
1~65000 cycles |
|||
Burst mode |
Internal, External, Single |
|||
FSK, ASK, PSK (Output A) |
||||
FSK |
Free to set carrier waveform frequency and hopping frequency |
|||
ASK |
Free to set carrier waveform amplitude and hopping amplitude |
|||
PSK |
Hopping phase: 0~360°, Max. resolution: 1° |
|||
Alternative rate |
10ms~60s |
|||
Output B |
||||
Waveform |
32 types waveforms, including Sine, Square, Pulse |
|||
Length |
1024 points |
|||
Sampling range |
12.5Msa/s |
|||
Amplitude resolution |
8 bits |
|||
Square wave duty cycle |
1%~99% |
|||
Frequency: Sine wave |
40mHz~1MHz; Other waveforms: 10mHz~100kHz |
|||
Resolution |
10mHz |
|||
Accuracy |
± (1x10 -5+10 mHz) |
|||
Amplitude |
50mVpp~20Vpp (high impedance) |
|||
Resolution |
20mVpp |
|||
Output impedance |
50Ω |
|||
Burst: Burst count |
1~65000 cycles |
|||
Burst mode |
Internal, External, Single |
|||
TTL output |
||||
Waveform characteristics |
Square wave, rise/fall time ≤20ns |
|||
Burst characteristics |
40mHz~1MHz |
|||
Amplitude characteristics |
TTL and CMOS compatible, low4V |
|||
Power amplifier (Optional) |
||||
Max. output power |
7W (8Ω), 1W (50Ω) |
|||
Max. output voltage |
22Vpp |
|||
Frequency bandwidth |
1Hz~200kHz |
|||
Frequency counter (Optional) |
||||
Frequency range |
1Hz~100MHz or 1Hz~150MHz |
|||
Input signal amplitude |
100mVpp~20Vpp |
|||
General |
||||
Power source |
110V/220V AC, (1±10%), 50Hz (1±5%) |
|||
Power consumption |
<30V |
|||
Environmental: Temperature |
0~40℃, humidity: <80% |
|||
Display |
TFT LCD |
|||
Dimension |
365*260*110mm |
|||
Weight |
3KG |
|||
Optional Function |
||||
Power amplifer |
||||
RS232 interface |
||||
Built-in frequency counter |